Description
Description
MICROMOTOR MICRONX FAST IMPLA-NX LED CLINICAL IMPLANT HANDPIECE COMPLETE ELEC (ISE-270M)
·Powerful torque up to 70N.cm(20:1 gear handpiece). ·Torque and RPM values can be checked in real time through the 5.5-inch large-screen LCD. ·When the load value is higher than the set torque value, a warning sound rings out for more than 3 seconds and operation of the item stops with a torque limiting function. ·Powerful optic motors to minimize shadow areas. ·If you press the RPM setting buttons ▲/▼ buttons at the same time for 2-3 seconds, the calibration function is enabled. ·By using memory, it is possible to store up to 9 different setting modes about torque and rpm values suitable for various users.


| Max 70N.cm | |
| ( 20:1 gear handpiece ) | |
| Torque limit function | |
| The beep sounds when load torque above torque value set by a user operates longer than 3 seconds and the operation stops to ensure patient’s safety. |
|
| Powerful optic motor | |
| It shows LED functioning within motor during the motor operation. |
| Real-time torque and RPM display | ![]() |
|
|---|---|---|
| The compact control unit shows real time rpm and torque through digital panel. It helps users to perform a surgery more precisely. |
||
| Program modes | ||
| Program button enables users to select 6 modes in turns _ Drilling,Tapping, Remove Tap, Implant, Remove, Lock Screw. Users can select them for each purpose. |
||
| Memory function | ||
| Users can save 9 personal settings using memory button, which makes it possible to load the different settings immediately in terms of program mode, rpm, torque, coolant, speed, gear ratio, turn direction. |
||
| Auto calibration function | ||
| Calibration function operates by simultaneously pressing +/- button for 2~3 seconds. Perform the Calibration function when the motor is initially used and operate this. function under no load status. |
||
![]() |
Thread Cutting Function | |
|---|---|---|
| Thread cutting is available in Tapping mode among 6 basic programs. | ||
| Thread Cutting? | ||
| The thread cutter function supports the surgery when makes tap for implants in to dense (D1) bone.
|



















































